Enterprise vault error validating a partition network share
Alternatively to installing this newer build, you may instead choose to install C redistributable components from "Transferred" job counter displays the same value with "Read" counter in cases when both source and target data movers are running on the same server (such as when backup proxy is writing data to its own disk).
(DWORD) registry value.• Network throttling rule does not apply if some job is already running at the time when the throttling period starts for the given rule.• In some scenarios, target data mover for CIFS-based backup repository starts on the backup server, rather than on the specified proxying server.• growing beyond 16385 bytes results in the following job runs fail with the "".• Network remapping functionality of replication job does not function correctly if performed within a single DVS (Distributed Virtual Switch), or when source and target VM are connected to more than one DVS.• Veeam Replica Summary growing beyond 16385 bytes results in the following job runs fail with the following error: "".• Full VM restore of a VM containing virtual disks with the same names creates a new VM with incorrect configuration if the original VM also had one or more snapshots present at the time of backup.
Topic for tracking major issues, patches and hot fixes for Veeam Backup & Replication 7.0B&R 7.0 update history at a glance:• Patch #4 (build 18.104.22.1681) [May 6, 2014] (KB1891)• Patch #3a (build 22.214.171.1249) [February 28, 2014] (superseded by Patch #4)• Patch #3 (build 126.96.36.1993) [February 12, 2014] (superseded by Patch #3a)• R2a Update (build 188.8.131.521) [December 2, 2013] (superseded by Patch #3)• R2 Update (build 184.108.40.2064) [November 13, 2013] (superseded by R2a)• Patch #1 (build 220.127.116.115) [September 27, 2013] (superseded by R2)In addition to adding basic support (as provided by other vendors), the intelligent load-balancing engine was enhanced to account for VSAN specifics.
As the result, for each VM the job will pick backup proxy running on VSAN cluster node with most of the virtual disks’ data available locally.
As the result, Backup Browser opens empty, without any volumes mounted.• Restoring to original location for volumes which are mounted to a folder (as opposed to a drive letter) fails when such volumes reside on GPT partition or dynamic disk.• Depending on where the file is placed on the tape, restore process may not calculate the file size correctly, resulting in corrupted file restored from good backup.• File to Tape job fails to process files with full path of exactly 260 symbols long with the "The generally available version of Patch #4 (build 18.104.22.1681) also addresses the following issue reported during pilot patch (build 22.214.171.1240) deployments:• Tape inventory fails on certain tape drives with the following error: "• Improved v Center Server hierarchy enumeration logic to speed up v Center Server registration process in a few times.• Intelligent load balancing can now be configured to give preference to backup proxy located on the same host using the • Added timeouts on all snapshot operations, including snapshot creation, deletion, import to off-host proxy, and reading snapshot data to prevent conditions with stuck snapshots due to environmental issues.• Maximum volume snapshot life time is now customizable using the (DWORD) registry value.
Default value is 72 hours, but customization may be necessary to allow full backup of very large VMs on slow backup hardware.• Added ability to configure SCVMM communication timeouts using the • Support for backing up files with file names longer than 260 characters, and directory names longer than 248 characters.• Support for devices that do not implement sending error in response to attempt of writing to write protected tape.• Support for devices that do not implement sending the end of media event, such as certain IBM tape drives.